[netperf-talk] netperf -t DLCL_STREAM

[Alexander Vinokur]

Netper-2.4.4

 

Hi netperf-talk,

 

I need to invoke 

netperf -H remotehost -t DLCL_STREAM -- -m 1024

 

Are there any mandatory options I need to set in line above, for
instance -D.

Any sample will be appreciated.

 

Thanks,

 

Alex Vinokur

 

 

-------------------------------- From netperf manual ----------

$ /opt/netperf/netperf -H remotehost -t DLCL_STREAM -- -m 1024 

Here are some of the DLPI-specific command line options for the
DLCL_STREAM test: 

-D devspec specify the local and/or remote DLPI device file name(s)
(fully-qualified). Syntax is the same as that of a sizespec. 

-m value specify the send size, in bytes, for the local system. This
must be less than or equal to the link MTU. 

-M value which behaves like -m, setting the receive size for the remote
system. 

-p ppaspec set the local and/or remote DLPI PPA(s). Syntax is the same
as that of a sizespec. 

-s value specify the 802.2 SAP for the test. This should not conflict
with any assigned SAP's. 

-w sizespec specify the local send/recv window sizes in frames (where
available). 

-W sizespec specify the remote send/recv window sizes in frames (where
available). 

 

 

Alex Vinokur
Development Expert

+972.9.7786378 (desk)
+972.50.7719352 (mobile)
+972.9.7786450 (fax)


AMDOCS > CUSTOMER EXPERIENCE SYSTEMS INNOVATION

 


This message and the information contained herein is proprietary and confidential and subject to the Amdocs policy statement,
you may review at http://www.amdocs.com/email_disclaimer.asp
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://www.netperf.org/pipermail/netperf-talk/attachments/20080522/0bbf5ca9/attachment.htm