[netperf-talk] When test some times the network card download
liuhu
liuhu at embedded.iscas.ac.cn
Wed Jan 11 18:56:19 PST 2006
Hi Rick,
I use netperf test on ARM board ,the network work module is 10M half/full duplex. but test
some times appear the following phenomenon:
TCP STREAM TEST from 0.0.0.0 (0.0.0.0) port 0 AF_INET to 192.168.1.2 (192.168.1.2) port 0 AF_INET
NETDEV WATCHDOG: eth0: transmit timed out
netperf: receive_response: no response received. errno 0 counter 0
....................
The TCP_STREAM result:
establish control: are you sure there is a netserver listening on 192.168.1.2 at port 12865?
establish_control could not establish the control connection from 0.0.0.0 port 0 address family AF_UN
SPEC to 192.168.1.2 port 12865 address family AF_UNSPEC
eth0 Link encap:Ethernet HWaddr 00:00:EB:FA:02:13
inet addr:192.168.1.7 Bcast:192.168.1.255 Mask:255.255.255.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:60330 errors:26929 dropped:0 overruns:26929 frame:0
TX packets:1845293 errors:446 dropped:0 overruns:4 carrier:442
collisions:0 txqueuelen:1000
RX bytes:4116539 (3.9 Mb) TX bytes:2755830578 (2628.1 Mb)
Interrupt:4 Base address:0xe300 DMA chan:ff
lo Link encap:Local Loopback
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)
then the follow test can not go on.
Why the network card eth0 transmit timed out?
Why the netperf receive_response?
It's my ARM board driver question or another ?
Best Regards
-------------------------------------------------
Liu Hu
CASKY eTech Co.Ltd.
TEL:86-10-51653155-138
FAX:86-10-62546836
E-mail:liuhu at embedded.iscas.ac.cn
-------------------------------------------------
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://www.netperf.org/pipermail/netperf-talk/attachments/20060112/1ca5df46/attachment.htm
More information about the netperf-talk
mailing list